A couple weeks ago I purchased a SunFounder 2channel 5v relay so I can use the Pi to control a device remotely (I am looking at you Mr. Christmas Tree)
This was the first time pulling it out of the box and immediately I was confused on how to hook this thing up as there were no diagrams or instructions. After much googling, reading and discovery this video explained exactly how I can hook this relay up to the PI.
I didn't have any female to female jumper wires this morning (ordered some though) I was able to use my existing pieces along with a few jumpers to get the relay wired.
Going back to the pin layout table I hooked up the wires from the relay to the gpio breakout on the breadboard.
The next step was to modify the led node app to control both gpio pins.
- As always a lot of resources out there on the internet
- This was fairly easy to setup once I was able to find the right guide.
- I need to a lot more reading before I hook this up to a control an outlet :-)
You might also be interested in these articles...
Developer and constant learner.